Mariner 2WD L4-2.5L (2009)
4. Remove the LH fuel tank strap bolt and position the strap aside.
-
To install, tighten to 55 Nm (41 lb-ft).
5. Partially lower the LH side of the fuel tank enough to access the fuel vapor tube assembly.
6. Disconnect the Fuel Tank Pressure (FTP) sensor electrical connector.
7. Disconnect the fuel vapor tube assembly-to-fuel tank quick connect coupling.
8. Disconnect the fuel vapor tube assembly-to-Evaporative Emission (EVAP) canister fuel vapor tube quick connect coupling.
9. Remove the fuel vapor tube assembly.
10. To install, reverse the removal procedure.
-
Carry out the Evaporative Emission System Leak Test. For additional information, refer to Evaporative Emission System Leak Test See:
Testing and Inspection.