Mariner 2WD L4-2.5L (2009)
8. Apply silicone to the main control sealing surface of the transaxle case.
9. Position the main control cover in place.
10. NOTICE: Inspect the main control cover grommet to make sure that the seal is on the inside of the main control cover. Transmission
fluid leak will occur.
NOTE: Install the stud bolts in the locations noted during disassembly.
Install the main control cover 8 bolts and 5 stud bolts.
-
Tighten to 12 Nm (106 lb-in).
11. Position the transmission fluid cooler tube bracket and transmission fluid cooler tubes in place and install the 2 nuts.
-
Tighten to 9 Nm (80 lb-in).