Mariner 2WD L4-2.5L Hybrid (2010)
Parking Assist Distance Sensor: Service and Repair
Active Park Assist Sensor
NOTE: LH side shown, RH side similar.
Removal
1. Remove the fender splash shield screws and lower bolts.
2. Position the fender splash shield aside and disconnect the electrical connector.
3. With a suitable tool (such as a flat-blade screwdriver) gently pry the retaining tabs to remove the active park assist sensor(s).
-
Remove the active park assist sensor(s) from the front bumper cover.
4. To install, reverse the removal procedure.
5. After installing the sensor(s), use the scan tool to verify that the active park assist sensor PIDs responding correctly. Carry out the Azimuth System
Check See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and Inspection/Component Tests and
General Diagnostics/Active Park Assist. If the active park assist sensor does not respond correctly, refer to Active Park Assist. See: Accessories
and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and Inspection/Component Tests and General
Diagnostics/Active Park Assist