Mariner 2WD V6-3.0L (2008)
4. Remove the 3 air deflector bolts.
-
To install, tighten to 5 Nm (44 lb-in).
5. Remove the 2 front bumper cover center scrivets from the front bumper cover.
6. Disconnect the fog lamp electrical connectors, if equipped.
7. Remove the 2 front bumper cover upper bolts and the front bumper cover.
-
To install, tighten to 8 Nm (71 lb-in).
8. To install, reverse the removal procedure.
-
Position the front bumper cover.
-
Push inward on the sides of the bumper cover near the bottom corner of the headlamp until you feel the bumper cover snap onto the bumper
slides.