Mariner 2WD V6-3.0L (2008)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. CAUTION: Care must be taken during the removal of the grommet to prevent damage. If the grommet is damaged, a new sensor may
need to be installed, even though the sensor is functional in all other aspects.
Remove the grommet from the body.
^
When removing the body grommet, rotate the grommet into a position which allows the use of a small screwdriver to release the tabs on the
underside of the grommet. These 2 tabs are located at right angles to the sensor wire.