Mariner 2WD V6-3.0L (2008)
Hose/Line HVAC: Service and Repair
Evaporator Inlet Line
EVAPORATOR INLET LINE
Removal and Installation
NOTE: Installation of a new receiver/drier is not required when repairing the air conditioning system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the receiver/drier.
1. Recover the refrigerant.
2. Remove the evaporator inlet line bracket nut.
-
To install, tighten to 8 Nm (71 lb-in).
3. Remove the receiver/drier outlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (11 lb-ft).
4. Remove the thermostatic expansion valve (TXV) fitting nut and disconnect the fitting.
-
Discard the gasket seals.
-
To install, tighten to 15 Nm (11 lb-ft).
5. Remove the evaporator inlet line.
6. To install, reverse the removal procedure.