Mariner 2WD V6-3.0L (2008)
Part 2
Removal and Installation
WARNING: Keep the sliding inner cable of the accelerator cable, the accelerator pedal and the pedal shaft free of contact with surrounding
components such as wiring, hoses, sound insulation and floor carpeting. Contact in these areas may prevent movement of the accelerator cable,
reducing the ability to decelerate the vehicle. Failure to follow these instructions may result in serious personal injury to the vehicle
occupant(s).
NOTE:
-
The accelerator pedal and shaft should travel smoothly from idle to wide-open throttle positions. Hesitation on return or prevention of return to the
idle position must not occur.
-
The sliding inner member of the accelerator cable should not be lubricated and is not repairable.
1. Remove the cable from the accelerator pedal.
2. Remove the accelerator cable grommet from the dash panel.
3. Remove the bolt and the accelerator cable bracket.
-
Detach the speed control cable pin-type retainer from the accelerator cable bracket.
-
To install, tighten to 9 Nm (80 lb-in).
4. Remove the 2 bolts and the accelerator control cover shield.
-
To install, tighten to 4 Nm (35 lb-in).
5. Disconnect the accelerator cable from the throttle body.
6. Squeeze the tabs and remove the accelerator cable from the bracket.
7. Detach the accelerator cable retainer.
8. Remove the accelerator cable.
9. To install, reverse the removal procedure.
