Mariner 2WD V6-3.0L (2008)
Seat Position Sensor: Service and Repair
SEAT POSITION SENSOR
Removal and Installation
WARNING: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in
serious personal injury or death.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. Raise the driver seat and position it in the middle of the track.
2. Depower the SRS.
3. Remove the driver seat.
4. Disconnect the seat position sensor electrical connector.
5. Push apart the 2 tabs, then push inward to release the seat position sensor locking clip.