Mariner 2WD V6-3.0L (2008)
18. Make sure the manual valve does not fall out of the main control valve body while removing from the vehicle.
Installation
All vehicles
1. Install the manual control lever in the main control valve body.
2. NOTE: Inspect the solenoid valve body harness connector O-ring seal for damage. If damaged, install a new O-ring seal, before installing the
connector into the case.
Depress the retaining tabs and push the solenoid valve body electrical connector up through the transaxle case.
3. Position the main control valve body in place while connecting the manual valve link.
