Mariner 2WD V6-3.0L (2008)
Transmission Speed Sensor: Service and Repair
Turbine Shaft Speed (TSS) Sensor
Turbine Shaft Speed (TSS) Sensor
Material
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the 7 retainers and the LH splash shield.
^
To install, tighten to 10 Nm (89 lb-in).
3. Remove the turbine shaft speed (TSS) sensor
1
Disconnect the TSS electrical connector.
2
Remove the TSS sensor bolt.
3
Remove the TSS sensor.
^
To install, tighten to 12 Nm (9 lb-ft).