Mariner 2WD V6-3.0L VIN 1 (2006)
The single cycle warning messages display once whenever the ignition switch is turned to the ON position or a fault occurs in a system, and can be
cleared by pressing the RESET button. The single cycle warning messages are:
-
liftgate ajar
-
service emission system
-
low brake fluid
-
service brake system
-
check left headlamp
-
check right headlamp
-
check left turn lamps
-
check right turn lamps
-
check left high beam
-
check right high beam
-
check fuel cap
-
change oil soon
-
change oil now
-
low fuel
-
service 4x4
-
turn signal on
-
regen disabled (Escape Hybrid)
-
speed control on (Escape Hybrid)
-
low tire pressure
-
tire monitor fault
-
tire sensor fault
-
train tires
-
tires trained
-
tires not trained
The repetitive warning message (park brake ON) displays whenever the ignition switch is turned to the ON position or a fault occurs in a system.
The repetitive warning message appears again after a 10-minute interval until the condition is corrected.
The non-resettable warning messages display whenever the ignition switch is turned to the ON position and a fault occurs in a system. The fault
must be corrected to clear the non-resettable warning messages.
The non-resettable warning messages are:
-
high engine temperature
-
driver door ajar
-
passenger door ajar
-
driver rear door ajar
-
passenger rear door ajar
-
stop safely now (Escape Hybrid)
Temporary Alert Messages
The temporary alert display interrupts the current display to show the status of an event that has just happened. The temporary alert messages are:
-
4x4 locked temporarily
-
4x4 disabled temporarily
-
4x4 auto restored
Inspection and Verification
INSPECTION AND VERIFICATION
1. Verify the customer concern.
Visual Inspection Chart
