Mariner 2WD V6-3.0L VIN 1 (2006)
2
Detach the wire harness.
3
Remove the 3 nuts and position the speed control actuator aside.
-
To install, tighten to 7 Nm (62 lb-in).
4. Remove the 2 compressor manifold and tube assembly bracket nuts.
-
To install, tighten to 8 Nm (71 lb-in).
5. Disconnect the compressor manifold and tube spring lock coupling at the suction accumulator.
-
Discard the O-ring seals.
6. Remove the front bumper cover.
7. Remove the condenser core inlet fitting nut and disconnect the condenser core inlet fitting.
-
Discard the O-ring seal.
-
To install, tighten to 8 Nm (71 lb-in).
8. Remove the RH splash shield.
9. If equipped, disconnect the engine block heater.
10. Disconnect the A/C compressor electrical connector.
11. Remove the compressor manifold bolt.
-
To install, tighten to 20 Nm (15 lb-ft).
12. Remove the compressor manifold and tube assembly.
-
Discard the O-ring seals.
13. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
14. Evacuate, leak test and charge the refrigerant system.
Condenser to Evaporator Line
CONDENSER TO EVAPORATOR LINE
