Mariner 2WD V6-3.0L VIN 1 (2006)
Evaporator Inlet Line
EVAPORATOR INLET LINE
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
1. Recover the refrigerant.
2. Loosen the nut and disconnect the passenger zone valve outlet tube-O fitting.
-
Discard the O-ring seals.
-
To install, tighten to 17 Nm (13 lb-ft).
3. Loosen the nut and disconnect the evaporator inlet line tube-O fitting.
-
Discard the O-ring seals.
-
To install, tighten to 24 Nm (18 lb-ft).
4. Remove the evaporator inlet line.
5. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
6. Evacuate, leak test and charge the refrigerant system.
Evaporator Inlet Line - Orifice Tube
EVAPORATOR INLET LINE - ORIFICE TUBE