Mariner 2WD V6-3.0L VIN 1 (2006)
-
Inspect the seat side air bag deployment chute and the seat side air bag cavity in the seat back pad for any foreign objects. If any foreign objects
are found remove them. Failure to do so may result in personal injury in the event of an air bag deployment.
-
Before installing the side air bag module, check it for damage and foreign objects. If the air bag module is damaged, replace it. If any foreign
objects are found, remove them. Failure to do so may result in personal injury, in the event of an air bag deployment.
-
If the air bag deployment chute is not properly positioned, the side air bag may not deploy properly.
-
If the air bag cover has separated or the air bag material has been exposed, install a new side air bag module. Do not attempt to repair the air bag
module. Failure to do so may result in personal injury in the event of an air bag deployment.
CAUTION: Make sure the side air bag module wiring harness is not pinched between the side air bag module and the mounting bracket.
All seats
1. Install the side air bag module and nuts onto the seat backrest frame mounting bracket.
-
To install, tighten to 5 Nm (44 lb-in).
2. Attach the 2 side air bag module wiring harness retainers to the seat backrest frame.
3. Roll down the seat trim cover to the side air bag module.
4. WARNING: Check the side air bag deployment chute for damage. The deployment chute must not be repaired. If there is any damage to
the deployment chute, the seat back trim cover and deployment chute must be installed new as a unit.
Feed the side air bag module deployment chute, J-clips, and hook and loop retainer back through the side air bag module seat back foam opening.
