Mariner 2WD V6-3.0L VIN 1 (2006)
Suspension Strut / Shock Absorber: Service and Repair
Rear
Shock Absorber
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the rear quarter trim panel.
3. Remove the upper shock absorber nuts, washer and bushing.
^
To install, tighten to 18 Nm (13 ft. lbs.).
4. Remove the lower shock absorber nut, washer and bolt.
^
To install, tighten to 175 (129 ft. lbs.).
5. Remove the shock absorber and the bushing.
6. To install, reverse the removal procedure.