Mariner 4WD L4-2.3L VIN Z (2005)
12. Remove the two nuts at the lift links, then remove the seat position sensor and bracket.
13. NOTE:
-
The drive tube is press-fit to stub shafts on each end. A hammer may be necessary to separate the drive tube.
-
The drive tube must be clamped at the inboard track gear stub shaft to allow the drive tube to separate at the seat track motor gear stub shaft.
Clamp the locking pliers on the flats of the drive tube where it reaches over the inboard track gear stub shaft. Tap on the locking pliers, separate
the drive tube from the seat track motor assembly stub shaft and remove the inboard track and drive tube.
14. Remove the two nuts.
15. Remove the outboard retainer clip.