Mariner 4WD L4-2.3L VIN Z (2005)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor-Front
Wheel Speed Sensor-Front
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: The harness connector is located in the engine compartment.
Disconnect the electrical connector.
3. Using a suitable tool, remove the grommet.
4. Remove the front wheel speed sensor wire from the retainer.
5. Remove the 2 front wheel speed sensor wire bolts.
^
To install, tighten to 9 Nm (80 inch lbs.).