Mariner 4WD L4-2.3L VIN Z (2005)
2. NOTE: Do not remove the rear knuckle cam nut and wheel knuckle bolts. If removed, clean the serrations in the bushing sleeve with a wire brush
and install a new wheel knuckle bolt and cam nut.
Loosen the LH and RH rear wheel knuckle bolts.
3. Turn the LH and RH adjusting cams simultaneously until the toe is within specification.
4. Tighten the LH and RH rear wheel knuckle bolts.
^
Using a suitable tool, hold the adjustment cam nut stationary while tightening the rear wheel knuckle bolt.
^
Tighten to 115 Nm (85 ft. lbs.).