Mariner 4WD L4-2.3L VIN Z (2005)
3. Cut and strip the wires near the electrical connector.
4. Obtain 2 wires (20 gauge minimum) at least 6.1-meters (20-feet) long and attach 1 end of each wire to stripped ends of the pretensioner wires.
Safety belt retractor pretensioner
5. Cut off 125 mm (4.92 in) of the vehicle body harness with the connector and strip 25 mm (1 inch) of insulation off the wires.
6. Obtain 2 wires (20 gauge minimum) at least 6.1-meters (20-feet) long and attach 1 end of each wire to stripped ends of the pretensioner wires.
All pretensioners
7. Position the safety belt retractor/buckle pretensioner assembly on a flat surface in an open outdoor area so that moveable parts do not contact the
support surface.
8. Remain at least 6.1-meters (20-feet) away from the safety belt pretensioner.
