Mariner 4WD L4-2.3L VIN Z (2005)
Inspect the pulley for paint marks in the web area near the hub. If there are no paint marks, or one paint mark, use a paint pencil to mark the web
area of the pulley near the hub. Using the special tool, install the power steering pump pulley.
2. Using the special tool, install a new seal on the power steering pressure hose fitting.
^
Remove and discard the original seal.
^
Stretch the seal over the seal replacer and slide it onto the tube nut.
3. Position the power steering pump and install the upper bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
4. Connect the power steering suction hose and clamp.
5. Position the power steering pressure line bracket and install the nut.
^
Tighten to 10 Nm (89 inch lbs.).
6. Raise the vehicle.
7. Install the lower power steering bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
8. Connect the power steering line fitting nut.
^
Tighten to 65 Nm (48 ft. lbs.).
9. Connect the power steering pressure switch electrical connector.
10. Install the drive belt. Refer to Drive Belts, Mounts, Brackets and Accessories.
11. Fill and leak check the power steering system.
