Mariner 4WD L4-2.5L (2010)
Parking Assist Control Module: Service and Repair
Parking Aid Module (PAM)
Removal and Installation
1. NOTE: Module configuration is only required if a new Parking Aid Module (PAM) is being installed.
Upload the PAM configuration information to the scan tool.
2. Remove the RH rear quarter trim panel.
3. If replacing the parking aid speaker only, proceed as follows:
-
Disconnect the electrical connector.
-
Disengage the clips.
-
Remove the parking aid speaker.
4. If replacing the PAM, proceed as follows:
-
Disconnect the electrical connector.
-
Remove the 2 screws.
-
Remove the PAM.
5. To install, reverse the removal procedure.
-
Download the configuration information to the PAM. For additional information, refer to PMI in Information Bus. See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning