Mariner 4WD L4-2.5L (2010)
Engine Block Heater: Service and Repair
Block Heater
2.5L
3.0L
Removal and Installation
1. Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding See: Cooling System/Service and
Repair.
2. NOTICE: Make sure that the block heater wiring is routed and secured away from rotating or hot components, or damage to the wiring
can occur.
Disconnect the block heater electrical connector.
3. Remove the block heater.
-
To install, tighten to 40 Nm (30 lb-ft) (2.5L).