Mariner 4WD L4-2.5L (2010)
![background image](/mercury/mariner_4wd/l4-2.5l/Page-1848001.png)
Air Door Actuator / Motor: Service and Repair
Mode Door Actuator - Air Inlet Door
Mode Door Actuator - Air Inlet Door
Removal and Installation
1. Remove the heater core and evaporator core housing. For additional information, refer to Heater Core And Evaporator Core Housing See:
Housing Assembly HVAC/Service and Repair/Removal and Replacement.
2. Disconnect the air inlet mode door actuator electrical connector.
3. Remove the 2 air inlet mode door actuator screws.
-
To install, tighten to 3 Nm (27 lb-in).
4. Remove the air inlet mode door actuator.
5. To install, reverse the removal procedure.