Mariner 4WD L4-2.5L (2010)
NOTE: When re-running the network test, the network test application must be first closed or the screen display reverts back to the prior run network
test results.
-
Disconnect: SJB Fuse 46 (7.5A) .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. GO to Pinpoint Test F. See: Pinpoint Test F: The Occupant Classification System Module (OCSM) Does Not Respond To
The Scan Tool
No
INSTALL the removed fuse. GO to S13.
-------------------------------------------------
S13 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE IC DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display reverts back to the prior run network
test results.
-
Disconnect: SJB Fuses 26 (10A) and 29 (5A) .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. GO to Pinpoint Test C. See: Pinpoint Test C: The Instrument Cluster (IC) Does Not Respond To The Scan Tool
No
INSTALL the removed fuses.
If the vehicle is equipped with an Accessory Protocol Interface Module (APIM), GO to S14.
If the vehicle is not equipped with an APIM, GO to S15.
-------------------------------------------------
S14 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display reverts back to the prior run network
test results.
-
Disconnect: SJB Fuse 3 (15A) .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. GO to Pinpoint Test R. See: Pinpoint Test R: The Accessory Protocol Interface Module (APIM) Does Not Respond To
The Scan Tool
No
INSTALL the removed fuse. GO to S15.
-------------------------------------------------
S15 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE ABS MODULE AND THE ACCM DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display reverts back to the prior run network
test results.