Mariner 4WD L4-2.5L (2010)
Oil Separator: Service and Repair
Crankcase Vent Oil Separator
Removal and Installation
1. Remove the intake manifold. For additional information, refer to Engine.
2. Release the coolant bypass hose from the clip.
3. NOTE: Remove and discard the crankcase vent oil separator gasket.
Remove the 8 bolts, the crankcase vent oil separator.
-
To install, tighten to 10 Nm (89 lb-in).
4. To install, reverse the removal procedure.
-
Clean and inspect the sealing surfaces.
-
Install a new crankcase vent oil separator gasket.