Mariner 4WD L4-2.5L (2010)
14. Remove the 2 bolts and separate the solenoid body from the main control valve body.
Installation
1. Install the solenoid body onto the main control valve body. Install the 2 bolts.
-
Tighten to 10 Nm (89 lb-in).
2. NOTE: If cleaning the main control assembly or inspecting the valves, refer to Main Control Valve Body See: Transmission and
Drivetrain/Automatic Transmission/Transaxle/Valve Body/Service and Repair/Main Control Valve Body. If installing a new main control
assembly, continue with this procedure.
Position the OSS and TR sensor wiring harnesses aside and install the main control-to-transaxle case separator plate.
3. NOTE: Make sure that the manual lever pin (part of the TR sensor) is correctly installed in the manual valve.