Mariner 4WD L4-2.5L (2010)
29. Be sure the stud bolt is in the correct location as noted during disassembly. Install the torque converter housing on the transaxle case and install the
17 bolts. Tighten to 18 lb-ft (24 N.m). (Figure 21)
30. Remove the turbine shaft seal protector 307-635.
31. Using the torque converter handle 307-091, install the torque converter.
32. Remove the torque converter handle 307-091.
33. Install the torque converter retainer 307-566.
34. Remove the transaxle from the bench-mounted holding fixture.
35. Remove the holding fixture 307-625.
36. Install transaxle and refill transaxle fluid following WSM, Section 307-01.
37. To correctly set and check the transmission fluid level monitor the transmission fluid temperature (TFT) Parameter Identification (PID) using
Integrated Diagnostic System (IDS)/ Portable Diagnostic Software (PDS) scan tool. Correct fluid level will read in the cross hatch area of the
dipstick at normal operating temperature 185-200 °F (85-93 °C).
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
102001A
2009-2010 Escape,
5.4 Hrs.
Mariner 4X2 2.5L: Replace
The Drive Chain In The
Transmission. (Do Not Use
With Any Other Labor
Operations)
102001A
2009-2010 Escape,
5.7 Hrs.
Mariner 4X2 3.0L: Replace
The Drive Chain In The
Transmission. (Do Not Use
With Any Other Labor
Operations)
102001B
2009-2010 Escape,
6.0 Hrs.
Mariner 4X4 2.5L: Replace
The Drive Chain In The
Transmission. (Do Not Use
With Any Other Labor
Operations)
102001B
2009-2010 Escape,
6.5 Hrs.
Mariner 4X4 3.0L: Replace
The Drive Chain In The