mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Sensors and Switches - A/T > < Manual Control Lever Shaft Seal|Page 4205
Page 3
background image

4. Install the front LH halfshaft. For additional information, refer to Drive Axles, Bearings and Joints.

5. Fill with clean transmission fluid to the correct level. For additional information, refer to Transmission Fluid Drain and Refill  See: Service and

Repair/Procedures/Transmission Fluid Drain and Refill.

Sensors and Switches - A/T > < Manual Control Lever Shaft Seal|Page 4205