Mariner 4WD L4-2.5L (2010)
Drive/Propeller Shaft: Description and Operation
Driveshaft
NOTICE: All driveshaft assemblies are balanced. If undercoating the vehicle, protect the driveshaft to prevent overspray of any undercoating
material or an unbalanced condition may occur.
The driveshaft consists of:
-
spot-welded balance weights.
-
a front CV joint at the Power Transfer Unit (PTU).
-
a center support bearing assembly with a ground strap.
-
staked and snap ring type U-joints.
-
U-joint cap straps for the center U-joint.
-
square flanged rear U-joint.
The driveshaft is a 2-piece shaft which transfers the rotational torque from the PTU to the rear drive axle. The driveshaft uses CV joints, U-joints and a
center support for consistent operation through varying lengths and angles.