Mariner 4WD V6-3.0L (2010)
Air Door Actuator / Motor: Service and Repair
Mode Door Actuator - Defrost/Panel/Floor Door
Mode Door Actuator - Defrost/Panel/Floor Door
Removal and Installation
NOTE: The defrost/panel/floor mode door actuator can be accessed from below the LH side of the instrument panel.
1. Disconnect the defrost/panel/floor mode door actuator electrical connector.
2. Remove the 2 defrost/panel/floor mode door actuator screws.
-
To install, tighten to 3 Nm (27 lb-in).
3. Remove the defrost/panel/floor mode door actuator.
4. To install, reverse the removal procedure.