Marquis L4-140 2.3L VIN A 2-bbl (1984)
Figure 12
4.
Position the new oil outlet tube (E5RY-6B749-B) to the right side of the engine and connect the tube to the oil cooler outlet hose (E5ZZ-18472-A)
routed over the rocker cover (Figure 12). Do not tighten the clamp.
5.
Connect the other end of the oil cooler outlet tube (E5RY-6B749-B) to the water pump with formed hose (E5ZZ-18472-C). See Figure 12. Do not
tighten the clamp.
6.
Position the new heater water inlet tube (E5ZZ- 18B402-A) to the right side of the engine above the oil cooler outlet tube (E5RY-6B749-B)
(Figure 12). Then connect the tube to the thermostat housing fitting with formed hose (E5ZZ-18472-B).
NOTE:
On 1983 2.3L turbo and 1983-84 Canadian 2.3L engines, the thermostat housing (E37E-8594-AB) must be replaced with a new
thermostat housing (D8FZ- 8592-A) with gasket (E4ZZ-8255-A).
7.
Connect the heater water inlet tube to the heater core with hose (E5SZ-18472-A: standard heater or manual A/C-heater, or E5SZ-18D371-B: ATC)
as shown in Figure 12.
8.
Install clamp (E3ZZ-18481-B) with bolt (N605771- S47) to retain the two tubes to the right front side of the engine rocker cover (Figure 12).
9.
Install the spring clip (N802623-S2) on the inlet and outlet tubes at the right rear side of the engine near the bend of the inlet tube (Figure 12).
10.
Tighten all hose clamps to 22-30 in.lbs. torque.
11.
Tighten the engine lifting bracket on the exhaust manifold stud.
12.
Fill the cooling system following the procedure given in the Car Shop Manual.
13.
Start the engine and with the air conditioner operating, accelerate the engine from 1100 to 14OO rpm to assure the noise condition has been
corrected.
PARTS INFORMATION - COMPRESSOR BRACES
PART NAME
PART NUMBER
QTY.
Old Parts - Remove and Discard
Bolt
N606063-S100
2
Brace - Front
E3SH-19D894-AA
1
Spacer
389780-S
1
V-Belt - A/C Drive
E3AE-8620-DA
1
Pulley - Water Pump
E3ZE-8509-EA
1