Merkur Scorpio V6-179 2.9L (1989)
29.
Open armrest door to gain and remove two switch panel retaining screws.
30.
Remove rear power window switches from floor console to center panel.
31.
Remove rear power cutoff switch from floor console center panel.
32.
Remove fuel filler door switch from switch console.
33.
Remove floor console center panel by lifting rear edge and moving center panel backward to disengage from console, Fig. 80.
34.
Remove floor console center panel (with parking brake boot) from parking brake.
35.
Remove ash receptacle, then two front console attaching screws.
36.
Lift carpet at each side of console to expose attaching screws, then remove screws.
37.
Remove two attaching screws inside cassette storage bin.
38.
Remove gear selector knob, then the console.
39.
Remove gear selector lamp from selector lever guide bracket.
Fig. 81 Removing Gear Selector. Scorpio
40.
Remove four gear selector attaching bolts, then raise gear selector and remove shift rod retaining clip, Fig. 81.
41.
Remove shift mechanism and control linkage.
42.
Remove clip at edge of lower trim panel near steering column.
43.
Pull trim panel forward and lift to release.
44.
Reverse procedure to install.
