Merkur Scorpio V6-179 2.9L (1989)
27.
Fill the plastic dirt extruder with long life lubricant C1AZ-19590-B or equivalent and hand install until bottomed on gear housing. Use a twisting
motion to force the dirt excluder onto the larger ground diameter. Wipe off excess grease and inspect dirt extruder to ensure that it is located on
the larger (ground) outer diameter of the input shaft and bottomed on the housing.
28.
Install new tie rods. Install bellows and clamps. Refer to TIE RODS & BELLOWS for installation.
29.
Install jam nuts and tie rod ends.
Power
DISASSEMBLE
Fig. 1 Exploded View Of ZF Steering Gear
