Merkur Xr4ti L4-140 2.3L SOHC Turbo (1985)
22.
Pull rearward on the clutch release cable and disengage from the release lever.
23.
Remove the attaching screws from the speedometer cable routing clips (two places). Position the cable out of the way on the left side of the
vehicle.
24.
Remove the bolt attaching the engine rear cover plate to the flywheel housing.
25.
Remove the flywheel housing attaching bolts located at the top of the housing.
26.
Remove the four (4) remaining flywheel housing attaching bolts.
27.
Pull the transmission rearward until the flywheel housing contacts the body. Raise the rear of the transmission and pull rearward to clear the body.
Lower the rear of the transmission and pull rearward to remove.
Figure 6
28.
Remove the back-up lamp switch and neutral safety switch from the extension housing, Figure 6.
Figure 7
29.
Using a brass drift and hammer, drive the welsh plug out of the extension housing, Figure 7.
