Milan L4-2.3L VIN Z (2006)
14. Remove the 2 engine roll restrictor bracket bolts.
^
Tighten to 90 Nm (66 ft. lbs.).
15. Using 2 suitable jack stands, support the rear of the subframe assembly.
16. NOTE: LH shown, RH similar.
Remove and discard the 4 subframe bracket-to-body bolts, the 2 subframe bracket-to-subframe nuts and lower the rear of the subframe.
^
To install, tighten the bolts to 103 Nm (76 ft. lbs.).
^
To install, tighten the nuts to 150 Nm (111 ft. lbs.).
17. Remove RH steering gear-to-subframe bolt.
^
To install, tighten to 107 Nm (79 ft. lbs.).
18. Remove the 2 LH steering gear-to-subframe bolts and position the steering gear to access the stabilizer bar LH bracket front nut.
^
To install, tighten to 107 Nm (79 ft. lbs.).