Milan L4-2.3L VIN Z (2006)
-
For Zephyr only, the LH and RH front window motor must be de-initialized, then initialized whenever the front window motor is removed from
the window regulator drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed or for any
operation in which grease or lubricants are applied to the window regulator or glass run.
1. Remove the door trim panel.
2. Remove the wiring harness cover plate and the access hole plug.
3. NOTE: If the window regulator motor is inoperative, remove it.
Lower the window enough to access the window glass clamp bolts through the access holes.
4. Loosen the B-pillar window glass clamp bolt and disconnect the door latch cable retainers.
-
To install, tighten to 6 Nm (53 lb-in).
5. Loosen the A-pillar window glass clamp bolt.
-
To install, tighten to 6 Nm (53 lb-in).
6. Tape the window in position, then lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.
7. Remove the front door speaker.