Milan AWD L4-2.3L (2008)
3. CAUTION: Only hand-tighten the 6 mm (0.23 inch) bolt or damage to the front cover can occur.
NOTE: This step will correctly align the crankshaft pulley to the crankshaft.
Install a standard 6 mm (0.23 inch) x 18 mm (0.7 inch) bolt through the crankshaft pulley and thread it into the front cover.
4. Assemble the special tools using 4 hardened washers in the locations shown.
5. CAUTION: The crankshaft must remain in the top dead center (TDC) position during installation of the pulley bolt or damage to the