Milan FWD L4-2.3L (2008)
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet
(MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Remove the battery.
2. Using a suitable suction device, remove the brake fluid from the remote reservoir.
3. Disconnect the brake fluid level switch electrical connector.
4. Disconnect the hose from the remote reservoir.
5. Remove the 2 nuts and the remote reservoir.
^
To install, tighten to 7 Nm (62 lb-inch).
6. Disconnect the brake fluid level switch harness from the brake fluid reservoir.
7. Remove the reservoir pin bolt and the brake fluid reservoir.
^
To install, tighten to 17 Nm (13 lb-ft).
8. Remove and discard the 2 seals.
9. NOTE: Install new seals. Lubricate the seals with clean, specified motor vehicle brake fluid.
To install, reverse the removal procedure.
^
Bleed the brake system.
^
If equipped with a manual transmission, bleed the clutch master cylinder.
