Milan FWD L4-2.3L (2008)
2. Remove the pressure line-to-power steering pump banjo bolt.
^
Discard the bolt and the 2 seals.
^
To install, tighten to 48 Nm (35 lb-ft).
3. Remove the 4 screws and position the RH fender splash shield aside.
4. Remove the 6 pin-type retainers (4 shown) and the RH splash shield.
3.0L and 3.5L engines
5. Remove the battery and battery tray. For additional information, refer to Battery.
3.0L engine
6. Remove the pressure line bracket-to-power steering fluid reservoir bolt.
^
Detach the electrical harness retainer from the pressure line bracket.
^
To install, tighten to 9 Nm (80 lb-in).
7. Remove the 2 pressure line bracket-to-engine bolts.
^
Detach the electrical harness retainer from the pressure line bracket.
^
To install, tighten to 9 Nm (80 lb-in).
3.5L engine
8. Remove the pressure line clip from the RH cylinder head engine lift hook.
9. Remove the pressure line bracket-to-RH valve cover stud nut.
^
Detach the electrical harness retainer from the pressure line bracket.
-
To install, tighten to 9 Nm (80 lb-in).
10. Remove the pressure line bracket-to-engine bolt.
^
Detach the electrical harness retainer from the pressure line bracket.
^
To install, tighten to 9 Nm (80 lb-in).
2.3L engine
11. Remove the pressure line bracket-to-subframe bolt.
^
To install, tighten to 9 Nm (80 lb-in).
12. Remove the pressure line bracket-to-steering gear bolt.
^
To install, tighten to 9 Nm (80 lb-in).
