Milan FWD L4-2.5L (2010)
Entertainment System Control Panel: Service and Repair
Front Display Interface Module (FDIM)
Front Display Interface Module (FDIM) - Fusion, Milan
NOTE: Without navigation shown, with navigation similar.
Removal and Installation
NOTE: Vehicles without navigation require Programmable Module Installation (PMI) when a new module is being installed. For vehicles without
navigation, the Front Display Interface Module (FDIM) is not a stand-alone module.
1. For vehicles without navigation, upload the FDIM configuration information to the scan tool. For additional information, refer to PMI in
Information Bus. See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and
Relearning
2. Remove the instrument panel center finish panel. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.
3. NOTICE: For vehicles with navigation, make sure not to bend the video cable when removing the FDIM.
Remove the 4 screws and the FDIM.
-
Disconnect the electrical connectors.
4. To install, reverse the removal procedure.
-
For vehicles without navigation, download the configuration information to the FDIM. For additional information, refer to PMI in Information
Bus. See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning