Milan FWD L4-2.5L (2010)
Rear Bumper Cover / Fascia: Removal and Replacement
Bumper Cover - Rear
Removal and Installation
1. Remove the rear lamp assemblies.
2. Remove the 6 pin-type retainers (3 each side) from the rear splash shield.
3. Remove the 2 pin-type retainers from the lower rear bumper cover.
4. Remove the 2 bolts and 2 pin-type retainers from the top of the rear bumper cover.
1. Remove the 2 bolts (1 shown).
2. Remove the 2 pin-type retainers (1 shown).
5. Remove the 2 upper bumper cover screws (1 each side).
6. If equipped, disconnect the license plate lamp electrical connector.
7. NOTE: The forward upper portion of the bumper cover must be pulled outward to unclip it from the bumper cover mounting bracket.
Reposition the bumper cover.
-
Pull outward on both sides of the bumper cover.
8. If equipped, disconnect the parking aid system electrical connector.
9. Route the wiring harness out of the body.
10. Remove the rear bumper cover.
11. To install, reverse the removal procedure.