Milan FWD L4-2.5L (2010)
Front Door Exterior Handle: Service and Repair
Door Handle Reinforcement - Exterior, Front
Door Handle Reinforcement - Exterior, Front
Removal and Installation
1. Remove the front door window regulator and motor. For additional information, refer to Windows and Glass.
2. Remove the exterior door handle. For additional information, refer to Exterior Door Handle See: Exterior Door Handle.
3. Loosen the exterior door handle reinforcement bolt.
-
To install, tighten to 6 Nm (53 lb-in)
4. Slide the exterior front door handle reinforcement to the front of the vehicle and push inside the door.
5. Remove the 3 front door latch bolts.
-
To install, tighten to 8 Nm (71 lb-in).
6. Remove the complete latch, carrier, and handle reinforcement assembly from the door.
7. Open the clip and disconnect the exterior front door handle actuating rod.
8. If required, disconnect the front door lock cylinder actuating rod.
9. Remove the screw and remove the front exterior door handle reinforcement from the carrier.
10. To install, reverse the removal procedure.