Milan FWD L4-2.5L (2010)
Removal
1. Remove the wheel and tire. For additional information, refer to Wheels and Tires.
2. Disconnect the parking brake cable from the brake caliper.
-
Pull back the parking brake lever.
-
Disconnect the cable from the parking brake lever.
-
Remove the cable conduit retaining clip.
-
Disconnect the cable from the brake caliper.
3. NOTICE: Do not allow the brake caliper to hang from the brake hose or damage to the hose can occur.
Remove the 2 brake caliper anchor plate bolts and position the brake caliper, brake pads and brake caliper anchor plate aside as an assembly.
-
Support the brake caliper, brake pads and brake caliper anchor plate assembly using mechanic's wire.
4. Remove the 2 brake disc screws and the brake disc.
Installation
1. NOTE: Make sure the brake disc-to-hub mounting surface is free of rust and foreign material before applying anti-seize lubricant.
Install the brake disc and the 2 brake disc screws.
-
Using the specified brake cleaner, clean the mating surfaces.
-
Apply specified lubricant as shown.
-
Tighten the screws to 20 Nm (177 lb-in).
2. NOTE: Make sure that the brake caliper hose is not twisted.
Position the brake caliper, brake pads and brake caliper anchor plate assembly and install the 2 brake caliper anchor plate bolts.
-
Tighten to 70 Nm (52 lb-ft).
3. Install the parking brake cable to the brake caliper.
-
Pull back the parking brake lever.
-
Connect the cable to the parking brake lever.
-
Install the cable conduit retaining clip.
