Milan FWD L4-2.5L (2010)
-
To install, tighten to 90 Nm (66 lb-ft).
4. NOTICE: The caliper guide pin boots must be seated correctly on the anchor plate or the guide pins may become contaminated.
Inspect the guide pin boots and make sure they are seated on the anchor plate correctly. The boot has a lip that fits under the edge of the anchor
plate extension.
5. NOTE: During installation, make sure that the brake caliper hose does not become twisted.
To install, reverse the removal procedure.
-
Install new copper washers.
-
Bleed the brake caliper. For additional information, refer to Component Bleeding in Brakes and Traction Control.
Brake Caliper Anchor Plate
Brake Caliper Anchor Plate
Removal and Installation
NOTE: The brake caliper and anchor plate are serviced together as a kit.
For additional information, refer to Brake Caliper See: Front Disc Brake/Brake Caliper .
Rear Disc Brake - Brake Caliper
Brake Caliper
NOTE: Front Wheel Drive (FWD) shown, All-Wheel Drive (AWD) similar.