Milan FWD L4-2.5L (2010)
![background image](/mercury/milan_fwd/l4-2.5l/Page-1693001.png)
Parking Brake Control: Service and Repair
Parking Brake Control
Removal and Installation
1. Remove the floor console. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.
2. Make sure the parking brake control is in the released position.
3. Disconnect the warning indicator switch electrical connector.
4. Loosen the parking brake control adjusting nut.
5. Remove the 2 parking brake control nuts.
-
To install, tighten to 20 Nm (177 lb-in).
6. Remove the parking brake control bolt and the parking brake control.
-
To install, tighten to 20 Nm (177 lb-in).
7. To install, reverse the removal procedure.
-
Adjust the parking brake cable. For additional information, refer to Parking Brake Cable Adjustment See: Parking Brake Cable/Adjustments.