Milan FWD L4-2.5L (2010)
1. Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding See: Service and Repair.
2. Remove the cooling fan motor and shroud. For additional information, refer to Cooling Fan Motor and Shroud - 2.5L, 3.0L (4V) See: Radiator
Cooling Fan/Radiator Cooling Fan Motor/Service and Repair.
3. Disconnect the radiator-to-degas bottle hose from the radiator.
4. If equipped, disconnect the 2 transmission cooling tubes from the radiator.
-
To install, tighten to 30 Nm (22 lb-ft).
5. Disconnect the lower radiator hose from the radiator.
6. Remove the 2 bolts from the upper radiator support brackets and position the radiator towards the engine and remove the 2 upper radiator support
brackets from the radiator.
-
To install, tighten to 10 Nm (89 lb-in).
7. Remove the A/C condenser-to-radiator pin-type retainer.
8. Squeeze the tabs and separate the A/C condenser from the radiator.
-
Remove the radiator.
9. To install, reverse the removal procedure.
10. Fill and bleed the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding See: Service and Repair.