Milan FWD L4-2.5L (2010)
4. Remove the bolt and the engine mount damper.
-
To install, tighten to 23 Nm (17 lb-ft).
5. Remove the bolt and the ground wire.
-
To install, tighten to 10 Nm (89 lb-in).
6. Remove the engine mount bracket bolt.
-
To install, tighten to 115 Nm (85 lb-ft).
7. Use the Engine Support Bar to raise the engine 25 mm (0.98 in).
8. Remove the 2 engine mount bracket nuts.
-
To install, tighten to 103 Nm (76 lb-ft).
9. Remove the nut, 2 bolts and the engine mount.
-
To install, tighten to 55 Nm (41 lb-ft).
10. NOTE: If the engine mount bracket is to be removed, the engine must be lowered to avoid contact between the A/C tubes and the engine mount
bracket.
Use the Engine Support Bar to lower the engine 25 mm (0.98 in).
-
Remove the engine mount bracket.
11. To install, reverse the removal procedure.