Milan FWD L4-2.5L (2010)
Removal and Installation
1. With vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.
3. Disconnect the vacuum supply hose.
-
Depress the quick connect locking ring.
-
Pull the vacuum hose out of the quick connect fitting.
4. Disconnect the fuel vapor return hose from the intake manifold.
5. Disconnect the Manifold Absolute Pressure (MAP) electrical connector.
6. Disconnect the Evaporative Emission (EVAP) canister purge valve electrical connector.
7. Disconnect the electronic throttle control electrical connector.
8. Disconnect the Knock Sensor (KS) electrical connector.
-
Detach the wire harness pin-type retainer.
9. Detach the heater hose pin-type retainer.
10. Detach the A/C compressor wiring harness retainer.
11. Detach the 2 wiring harness pin-type retainers from the intake manifold and position the wiring harness aside.
12. If equipped, remove the 7 screws and the underbody cover.
13. Remove the intake manifold lower bolt.
-
To install, tighten to 18 Nm (159 lb-in).