Milan FWD L4-2.5L (2010)
7. Install the engine mount. For additional information, refer to Engine Mount See: Drive Belts, Mounts, Brackets and Accessories/Engine
Mount/Service and Repair/Removal and Replacement.
8. Install the crankshaft pulley. For additional information, refer to Crankshaft Pulley See: Cylinder Block Assembly/Harmonic Balancer -
Crankshaft Pulley/Service and Repair.
9. NOTICE: Only hand-tighten the bolt or damage to the front cover can occur.
Install a standard 6 mm x 18 mm bolt through the crankshaft pulley and thread it into the front cover.
10. Install the CKP sensor and the 2 bolts.
-
Do not tighten the bolts at this time.
11. Using the Crank Alignment Tool, adjust the CKP sensor.
-
Tighten the bolts to 7 Nm (62 lb-in).
12. Connect the CKP sensor electrical connector.
13. Remove the 6 mm x 18 mm bolt.
14. If equipped, install the underbody cover and the 7 screws.