Milan FWD L4-2.5L (2010)
-
To install, tighten to 15 Nm (133 lb-in).
7. Remove the lower engine splash shield (if equipped).
8. Remove the compressor manifold bolt and detach the manifold from the A/C compressor.
-
Discard the gasket seals.
-
To install, tighten to 15 Nm (133 lb-in).
9. Remove the compressor manifold and tube assembly.
10. To install, reverse the removal procedure.
-
Install new gasket seals.
-
Add the correct amount of clean PAG oil to the refrigerant system.
11. Evacuate, leak test and charge the refrigerant system.